GE Industrial Solutions 6KCV300WPD - Manual (Page 185)

Input ports
Pos float
float
float
float
Reset
Preset
int
int
Output ports
executed description
always Set point to be followed [x]
.f actual ramp time used as reference to determine each ramp
time It must be positive. If not it is assumed as
positive
if previous Positive acceleration time for to go
and from 0 to RefSetPoint when is greater
than 0. It must be positive. If not it is assumed as
positive
if previous Positive deceleration lime for to go
output>=0 and from RefSetPoint to 0 when is greater
than 0. It must be positive. If not it is assumed as
positive
if previous Negative acceleration time for to
and go 0 to when is less
than 0. It must be positive. If not it is assumed as
positive
if previous Negative deceleration time for to
and go from to 0 when is less
than 0. It must be positive. If not it is assumed as
positive
always If Reset!=O, is set to 0
if If is set to
name type description
float
Ramp output
Set to 1 if decreasing ramp is used, otherwise it is
set to 0
int Set to 1 if increasing ramp is used, otherwise it is
set to 0
175