M&C TechGroup SP2000-H320_S2 Operator's manual - Manual (Page 21)

21
Gas sampling and gas conditioning technology 2-1.1.4-ME
13.4.2 VERSION SP2000-H320/S1 WITH ELECTRONIC TEMPERATURE CONTROLLER
The gas sample probe is supplied either as unit with a fixed and electrically connected temperature
controller, or the temperature controller is attached as separate unit for external mounting. Then, the
electrical connection is to be made as follows:

Remove the lid of the connection box on the gas sample probe. Inside the lid, you will find the
terminal connection plan.

Insert the mains cable (min. 3 x 1,5 mm
2
, terminal range 6
– 12mm) through the medium cable
gland of the gas sample probe and connect it to the appropriate terminals.

Insert the temperature sensor cable into the right cable gland of the gas sample probe and
connect it to the appropriate terminals.

Screw the lid on again.
Figure 10 Electrical connection SP2000-H320/S1 with electronic controller eg. type 703G
N O T E !
As sensor line an equalization line has to be provided. The cor-
responding thermo equalization terminals are provided inside
the connection box.