M&C TechGroup Gas Sample Probes Series SP Data sheet User Manual

Sample tubes for gas sample probes series sp, With g 3/4”-connection thread, Special features

M&C TechGroup Germany GmbH • Rehhecke 79 • 40885 Ratingen • Germany

[email protected] • www.mc-techgroup.com • Fon +49 2102 935-0 • Fax +49 2102 935-111

2.14

Embracing Challenge

Sampling of dust loaded process gases

Small volume, fast response time

Easy mounting and maintenance

Self-regulated electrical heater

Alarm contact for low temperature

Outdoor mounting with protective cover

Insitu probe tube optional

Special Features

Sample Tubes for
Gas Sample Probes Series SP®

with G 3/4”-connection thread

Sample tubes for series SP®

Application

The M&C sample tubes are used in combina-

tion with the M&C gas sample probes series

SP® for point selective continuous gas sam-

pling in processes with low dust loadings.

Description

The M&C probe sample tubes SP210/SS and

SP2000/... are selected according to the spe-

cific applications. Influencing process param-

eter are the gas composition, dust content,

water vapure saturation, temperature, pres-

sure and gas velocity.
Among the standard length “L1” other lengths

up to “L max” are available on request.
For applications with low sample gas flow,

sample tubes SP2000/SS-Vm are equipped

with volume displacers to decrease the reten-

tion time.
Gas sampling downstream a wet scrub-

ber with a high content of water carried

out with the M&C sampling tube SP32,

equipped with an integrated demister for

liquid drop collection.
Depending on the selected material, the M&C

sample tubes are equipped with a welded

thread adapter or a support adapter. They

are partly made of different material than the

tubes, depending on fabrication. See below

table.
The connection thread enables an easy

mounting into the mounting flange of the

M&C gas sample probes.
Further sampling accessories:
For a high dust load Pre-filter V20.., V12...
For lower deviation of dew point on process

side heated sample tubes SP30, SP35.

Technical specifications and illustrations are without

obligation, subject to modifications. 09.96/06.11