M&C TechGroup SP2000-H320_S2 Operator's manual - Manual (Page 14)

14
Gas sampling and gas conditioning technology 2-1.1.4-ME
The following photos show how to execute the above mentioned steps.
Figure 4 Dismounting of the filter housing lid

Check on the filter screw I whether the filter element J has been screwed hand-tight (see fig-
ure 20).

Then put in again the filter receiving part, set the handle C into position E, swing the clamp
clip back again and tighten the lid with the locking handle A.
Filter screw Seal
Filter screw adapter
Filter space
Holding clip
Strap bolt 93 S 2084
93 S 2084
Schutzhaube wärmeisoliert
90 S 0020
Type S-2K150
*
Filter element Type F-0,1GF150
90 F 0125 93 S 0053
Filter element
93 S 0055
93 S 0053
Adapter Seal
93 S 0055
93 S 0055
Seal I
L J L K
K
I
K J
Figure 5 Filter element receiving part