M&C TechGroup SP2200-H_C_I_BB_F Data sheet - Manual

M&C TechGroup Germany GmbH • Rehhecke 79 • 40885 Ratingen • Germany
[email protected] • www.mc-techgroup.com • Fon +49 2102 935-0 • Fax +49 2102 935-111
2.3
Embracing Challenge
ƒ ƒ
Heated sample probe with integrated
valves for:
ƒ ƒ
Calibration gas injection
ƒ ƒ
Probe outlet isolation
ƒ ƒ
Blow back
Special Features
Gas Sample Probe Series SP®
Version SP2200-H/C/I/BB and SP2200-H/C/I/BB/F
SP2200-H/C/I/BB(/F)
Description
The M&C probe SP2200-H/C/I/BB and /BB/F is
based on the standard probe SP2000-H.
• Calibration gas will be injected into the
probe through a check valve /C directly
to the sample outlet. No calibration gas
is lost into the stack.
• An isolation valve /I shuts off the sample
outlet from the internal filter area.
• Through a high flow rate check valve /
BB, which is fixed to the internal probe
area, blow back of the filter housing area
and the insitu probe tube will be done.
• Through a high flow rate check valve /
BB/F, which is fixed to the filter hous-
ing wall, blow back of the incorporated
ceramic filter will be done incl. the filter
area and the insitu probe tube.
Technical specifications and illustrations are without
obligation, subject to modifications. 10.04/06.06
Following options are included: SP2200-H...
Calibration gas connection tube connector 6 mm o.d.
Blow back gas connection tube connector 8 mm o.d.
Calibration gas injection valve /C
Isolation valve /I
Valve for blow back of the filter housing area /BB
Valve for blow back of the incorporated ceramic filter /BB/F