Setup in multicam, 1 introduction, 1 overview – EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual User Manual
Page 9: Verview
Issue 10.01.I
EVS
Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
2
2. Setup in Multicam
2.1 INTRODUCTION
2.1.1 O
VERVIEW
When you work in Spotbox mode, the ‘Setup Configuration’ module available in
the Multicam application, using the SHIFT-F2 keyboard combination, allows you to
configure the Multicam software and define server settings in relation to
timecodes, protocol communication, etc.
The other Multicam modules are discussed in the following manuals:
•
Monitoring modules in the XT Tech Ref Software manual
•
Multicam application in the User manual
This module contains several pages, i.e. windows, which are described in details
in this section:
Setup page and section
name
Content
Page 1
See Section 2.2 ‘General
Settings (Page 1)’,
on page 4.
It includes several general settings on the ttime
codes, the OSD, the VGA, the network, the clip
management, the record trains, the channel
names, the RS422 protocols.
Page 2
See Section 2.3 ‘VITC/ANC
Timecode Management (Page
2)’, on page 13
It includes detailed settings on the insertion of
VITC or ANC time codes, channel by channel.
Page 3
It includes settings on:
•
the priorities on the SDTI network
•
the SMPTE 334M packet management