EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual - Manual (Page 55)

Issue 10.01.I EVS Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
48
3.8.11 R
ECORD
T
RAIN
OUT
S
Possible values: Play through (default) / Freeze
When this parameter is set to “Freeze”, and an OUT point is marked in a record
train, Multicam will countdown to the OUT point and automatically freeze on that
picture (if the Post-Roll mode is disabled) or on that picture + the Post-Roll
duration (if the Post-Roll mode is enabled) when replaying that section.
When the parameter is set to “Play through”, Multicam will still countdown to the
OUT point, but will keep playing through this point. In a clip, Multicam always
freezes on the OUT point (or OUT point + Post-Roll duration when Post-Roll mode
is enabled).
3.8.12 F
REEZE ON
C
UE
P
OINTS
Possible values: No (default) / Yes
The purpose of this functionality is to allow marking cue points on any field of a
record train and freeze on the cue point when the playback reaches it. This is
similar to the freeze on OUT point functionality but because it will be done on cue
point, you will be able to freeze on any field (impossible with OUT points).
When playing record trains where cue points have been marked, the playout
freezes on the cue point if the parameter is set to “Yes”. It plays through if the
parameter is set to “No”.
The Post-Roll parameter is not taken into account for this functionality.