EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual - Manual (Page 74)

EVS Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
Issue 10.01.I
67
3.15 HYPERMOTION CONFIGURATION
Hypermotion Configuration p.6.4
[F1]Hypermotion : Yes
[F2]Recorder : CAM A [F6] RS422 : 6
[F3]Remote Controller : Hypermotion Only
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
The Hypermotion feature is a software option (license code 20) that allows
controlling a hypermotion camera from the Remote Panel.
3.15.1 H
YPERMOTION
Possible values: Yes, No (default)
When this parameter is set to ‘Yes’, the Hypermotion feature is active: Users can
access and use the Hypermotion menu on the Remote Panel via the SHIFT+D key
combination.
When this parameter is set to ‘No’, the Hypermotion feature is not active: The
Hypermotion menu can be accessed but not used on the Remote Panel.
3.15.2 R
ECORDER
Possible values: CAM A to CAM D. Default: last CAM
This parameter specifies the recorder channel to which the A/V material from the
hypermotion camera will be sent. The default value is the last CAM defined in the
channel configuration, for example CAM C in 3 IN 3 OUT configurations.
3.15.3 RS422
Possible values: Port #1 to Port #6. Default : Port #6
This parameter specifies on which RS422 port the commands for the hypermotion
camera must be sent.