EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual - Manual (Page 58)

EVS Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
Issue 10.01.I
51
3.9.2 C
ONFIRM
D
ELETE
C
LIP
Possible values: No (default) / Yes
No: clips are deleted immediately
Yes: a confirmation is required when deleting clips, either from the Remote or
from the keyboard.
Note
This parameter does not apply to the Clear All Clips command (Main
menu) which already has its own confirmation message.
3.9.3 A
UTO
N
AME
C
LIPS
Possible values: Disabled (default) / TC IN / CAM Name / ID Louth / VarID
If this function is enabled, the value of the selected field will automatically be
used to name the clip upon creation.
The values from the following fields can be used to automatically name clips:
Value Meaning
Disabled
(Default)
No name is assigned to a clip when it is created.
TC IN The time code of the IN point of the clip is automatically
assigned to a clip when it is created.
CAM Name The name of the recorder channel is automatically assigned to
a clip when it is created.
ID Louth The ID Louth of the clip, i.e. the unique identifier for the clip on
the XNet network, is assigned to a clip when it is created.
VarID The VarID of the clip is assigned to a clip when it is created.
When this option is selected, the VarID used to assign a name
to the clip will be limited to the first 8 characters of this field.
3.9.4 C
LIP
P
OST
-R
OLL
Possible range: 00s00fr to 30s00fr. Default: 02s00fr.
When the Post-Roll function is enabled from the secondary clip menu, the clip
will play through its OUT point for a duration defined by the Post-Roll parameter.
This is also valid inside record trains if the Record Train OUTs parameter is set to
“Freeze”.