EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual - Manual (Page 82)

EVS Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
Issue 10.01.I
75
GPI In Settings p.8.3
GPI# Channel/Device Port Function
5 [F1]RMT1 -- [F5]Play
6 [F2]RMT1 -- [F6]Next
7 [F3]RMT1 -- [F7]Skip
8 [F4]RMT1 -- [F8]Pause
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
For each GPI input, the operator has the possibility to define the following
parameters:
Channel/Device
This parameter specifies the channel that the GPI will affect or the device that
will send the GPI to the server.
A device can be an EVS Remote #1 or one of the protocols defined in page 7.1 (if
some GPI must be used by the AirBox in a mixed configuration LSM+AirBox, or if
GPIs must trigger some actions on a channel controlled by a Sony protocol, etc.).
If the operator selects EVS Remote #1, the GPI will trigger the selected action on
all channels controlled by that Remote Panel.
Function
This parameter specifies the function that the GPI will trigger: Play, Pause,
Recue, Previous (recue to previous clip inside the playlist), Next (go to next clip
inside the playlist), Skip (skip the next clip in the playlist), -------- (no action is
taken) or Tally. For more information on the possible functions, refer to the
explanation on page 4 of the Setup Configuration in Multicam.
If a GPI is assigned to an AVSP protocol for use with the EVS AirBox or AirEdit
application, the function of this GPI will be defined by the AirBox / AirEdit
software.
For the pinout of the GPI connector and wiring instructions, please refer to the XT
Tech Ref Hardware manual.