AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 174)

SIP – DECT OM System Manual Release 2.1 9 Appendix
depl-1230/1.3 Page: 174 (196)
9 Appendix
9.1 Declaration of Conformity
The CE mark on the product certifies its conformity with the technical guidelines for user
safety and electromagnetic compatibility, valid from the date of issue of the relevant
Declaration of Conformity pursuant to European Directive 99/5/EC.
The Declaration of Conformity can be viewed on the Aastra homepage.
9.2 Communications Regulation Information for Aastra DECT 142 US
9.2.1 FCC Notices (U.S. Only)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Modifications not expressly approved by this company could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Health and Safety Information
Exposure to Radio Frequency (RF) Signals:
The wireless phone is a radio transmitter and receiver. It is designed and manufactured not
to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission (FCC) of the U.S. Government. These limits are part of
comprehensive guidelines and establish permitted levels of RF energy for the general
population. The guidelines are based on the safety standards previously set by both U.S. and
international standards bodies. These standards include a substantial safety margin
designed to assure the safety of all persons, regardless of age and health.
This device and its antenna must not be co-located or operating in conjunction with any other
antenna or transmitter.