Configuring pp datasets, Subscribing pp datasets, Deleting pp datasets – AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN User Manual

Page 111: 6 configuring pp datasets, 7 subscribing pp datasets, 8 deleting pp datasets

SIP – DECT OM System Manual Release 2.1

6 OM Management Portal (OMP)

depl-1230/1.3

Page: 111 (196)

6.8.6

Configuring PP Datasets

Configuring PP datasets is only possible in configuration mode. To configure an existing
PP dataset proceed as follows:

1 In the task bar on the right of the

Portable parts

panel click on the

Configure

command.

– In the

Overview

submenu you can configure the whole PP dataset (user and device

data).
– In the

Users

submenu you can configure the PP user data.

– In the

Device

submenu you can configure the PP device data.

The PP detail panel opens.

2 Change the PP dataset as desired, see parameter description in chapter 6.8.4.

3 Press the

button.

6.8.7

Subscribing PP Datasets

After adding a PP dataset to the OMM, the PP must be subscribed. The OMM must first be
enabled to allow subscriptions to be take place from PP handsets. Subscribing PP datasets
is possible in the

Overview

panel and in the

Device

panel. To start subscription, press one

of the following commands in the

Portable parts

menu:

•

Subscription

: start PP subscription with configured IPEI. For more information on this

see chapter 5.7.3.1.

•

Wildcard subscription

: start PP wildcard subscription (without configured IPEI). In the

Wildcard subscription

dialog, which is now opened, enter the

Timeout

for this

subscription method. Press the

Start

button. For more information on this see chapter

5.7.3.2.

6.8.8

Deleting PP Datasets

Deleting PP datasets is only possible in configuration mode. You can delete the fixed
PP dataset or only the PP user data resp. the PP device data.

To delete one or more existing PP datasets proceed as follows:

1 Select the appropriate PP dataset(s) in the PP table by activating the corresponding

checkbox(es).

2 In the task bar on the right of the

Portable parts

panel click on the

Delete

command.

– In the

Overview

submenu the whole PP dataset will be deleted.

– In the

Users

submenu only the PP user data will be deleted.

– In the

Devices

submenu only the PP device data will be deleted.

The

Delete [xxx]

dialog opens showing a confirmation prompt.

3 Confirm the displayed prompt with