AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 164)

SIP – DECT OM System Manual Release 2.1 8 Maintenance
depl-1230/1.3 Page: 164 (196)
Menu Phonebook
RFPI 10FFF21 02
FE PP: FP:
-dBm 50 57 50
RPN 02 01 00
PARK: 1F-10-FF-F0-21 RFP ID: 02*
RFP ID: 02*
*The ID of RFP to which the PP is currently associated to.
Frame error
Field strength
RFP ID
In this example the PP is currently connected to the RFP with the number 02. The RFPs 01
and 00 are also visible. The number “10FFF221 02” on the upper right side refers to the
PARK (Example 1F-10-F2-21) of the SIP – DECT system and to the RFP to which the phone
is currently connected to.
8.3.2 Aastra DECT 142 / Aastra 142d Auto Call Test Mode
You can set the Aastra DECT 142 / Aastra 142d handset to “auto call test mode” with a few
keystrokes. In this mode the phone will call a specified number cyclically. You can use this
feature to generate traffic for test purposes. This mode is also active if the phone is on the
charger.
1 Press the Menu soft key.
2 Enter the following key sequence “R***76#”.
3 Select Auto Call Test.
4 Press OK.
5 Enter the phone number to call.
6 Press OK.
7 Enter a number of seconds between two calls.
8 Press OK.
9 Enter a number of seconds a call shall be active.
10 Press OK. The test will be started automatically.
11 To stop the test, switch the phone off and on again.
8.3.3 Aastra DECT 142 / Aastra 142d Auto Answer Test Mode
You can set the Aastra DECT 142 / Aastra 142d handset to “auto answer test mode” with a
few keystrokes. In this mode the phone will answer incoming calls automatically. You can
use this feature together with phones in the “auto call test mode” (see chapter 8.3.2) for test
purposes. This mode is also active if the phone is on the charger.