AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 166)

SIP – DECT OM System Manual Release 2.1 8 Maintenance
depl-1230/1.3 Page: 166 (196)
8.3.5 ssh user shell
Each RFP offers a lot of commands within the ssh shell. Most of them are useful for
diagnostic and may help experts to resolve failures.
Note: Some commands can harm the system operation.
The ssh access of an RFP is open if
• the RFP is connected to an OMM and the “Remote Access” is switched on or
• the RFP is not connected to an OMM.
To activate the ssh access of an RFP which has a connection to an OMM, activate the
Remote access checkbox on the OMM System settings web page (see also chapter 5.4.1).
Æ In the OMP, the ssh access is activated/deactivated in the General tab of the System
settings menu (see chapter 6.5.1).
8.3.5.1 Login
To log in to the ssh user shell:
1 Open ssh session to the IP DECT base station with the “Full access” user name.
2 Enter the password for the “Full access” account (see also 7.12.1).
The output should look like:
Welcome to IP RFP OpenMobility SIP Only Version 2.1.x
last reset cause: hardware reset (Power-on reset)
[email protected]'s password:
[email protected] >