AASTRA SIP-DECT (Release 2.1)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 154)

SIP – DECT OM System Manual Release 2.1 7 Configuration und Administration Aspects
depl-1230/1.3 Page: 154 (196)
The account data can be altered at the User account page of the OMM Web service (see
chapter 5.4.3).
The OMM delivers all the necessary account data to all connected RFPs. The RFPs save the
account data inside their permanent memory. This has some implications:
• An RFP out of the box uses the default account data as long as this RFP is not connected
to the OMM.
• An RFP which was connected for at least one time with the OMM uses the account data
from the OMM.
• When the account data are changed on the OMM, any not connected RFPs will continue
to use the older passwords.
7.12.1 Account Types
There are three different account types:
• Full access: This access type is the “normal” access for all the configuration. Using this
access it is allowed to configure the OMM and each RFP. On the ssh interface of an RFP
this access type allows login for debug information e. g. 'pinging an other RFP to check
visibility.
The factory setting for this account is
Name: 'omm'
Password: 'omm'
Active:
'n/a'
• Read only access: As the name suggests this access type is not allowed to configure
any item of the OMM installation. This access type can only be used on the OM Web
service. The account can be deactivated.
The factory setting for this account is
Name: 'user'
Password: 'user'
Active:
'yes
• root access: This access type is only applicable on the ssh interface of an RFP. Its
purpose is to get detailed information e. g. parameters from the kernel. The access using
this account type is not reachable from other hosts hence a login using the full access
type is necessary.
The factory setting for this account is
Name: 'root'
Password: '22222'
Active:
'n/a'
Please note: It is highly recommended not to use the “root access” account type. It is meant
for technical support only.