Xerox 701P40016 - Manual (Page 73)

6-1
6. Using Command Line Client
The Xerox Document Submission Command Line software
enables you to set up and submit print jobs by entering
commands in a DOS or Unix window, from a PC or Sun
workstation. This chapter describes the procedure and syntax for
entering the print and job setup commands.
To view more of the window or enable the scroll bars, right click
on the title bar for the Command Prompt window and then select
[Properties...]. Change the WIndow size to Width=100 and
Height-100. Select [OK]. Apply properties to the current window
only and select [OK]. Scroll bars should appear on the right of
the window.
Accessing the XDS Command Line software
The XDS Command Line software is installed as part of the
process of installing XDS Plus. Refer to the Installation Guide for
information on installing XDS Plus and all its components.
Accessing XDS Command Line from Windows
To open XDS Command Line from Windows, follow these steps:
1. Log on to your network.
2. From your workstation , open a command line prompt (such
as DOS) and navigate to the install directory.
The XDS Command Line DOS window opens, displaying the
XDSCL> prompt. You are now using XDS Command Line in
Multiple Command Mode and and may enter job setup and print
commands on the command line at this prompt.
Accessing XDS Command Line from Solaris and Mac OS X
Follow these steps to access XDS Command Line from Solaris: