Xerox 701P40016 - Manual (Page 111)

Guide to Printing Using Xerox Production Print Services Job ticket options
9-19
2. In the Covers dialog box, select either [Front and Back Same]
or [Front and Back Different] to add both a front and a back
cover to the job. Depending on your selection, either the
[Front Cover] and [Back Cover] fields or the [Both Covers]
field are displayed.
• Select [Front and Back Same] if the paper stock and the
sides printed will be the same for both the front and back
covers.
• Select [Front and Back Different] when the paper stock or
sides printed will be different for the front cover and the
back cover.
3. From the pop-up menu in the [Front Cover], [Back Cover], or
[Both Covers] field, select a stock number for the for one of
the covers, (or for both front and back covers if they will be
the same stock). The properties for the stock that was
previously specified for that number are displayed in the
[Stock] field.
4. If you want to select a different stock ID or specify different
properties for the stock number, select the [Stocks...] icon to
open the Paper Stocks dialog box.
a. On the Paper Stocks dialog box, select the same stock
number from the Stocks menu that you selected on the
Covers dialog box.
b. Program the stock for the cover. Refer to “Specifying
stocks for the job” and “Specifying stock properties,”
earlier in this chapter, for further information.
c. Select [OK] to close the Paper Stocks dialog box and
return to the Covers dialog box. Your new stock
specifications are displayed in the [Paper Stocks] field on
the Covers dialog box.
5. Select the sides of the cover that will be printed. The
available options are [None], [Side 1], [Side 2], and [Both
Sides].
6. If you selected [Front and Back Different], repeat steps 3
through 5 to program the remaining cover.
7. Select [OK] to save the covers programming and return to the
Job Ticket dialog box. The number of covers that you
specified (2, in this case) is displayed below the [Covers] icon
on the Job Ticket dialog box.
If you want to remove the covers programming, select
[Cancel].