ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 98)

Prestige 324 Intelligent Broadband Sharing Gateway
Remote Node Setup 9-1
Chapter 9
Remote Node Setup
This chapter shows you how to configure menu 11 and all its sub-menus including traffic redirect.
9.1 Introduction
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring a remote node. We will show you how to configure Menu
11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options and Menu 11.5 -
Remote Node Filter.
9.2 Remote Node Profile
From the main menu, select option 11 to display Menu 11.1 - Remote Node Profile. There are three
variations of this menu depending on whether you choose Ethernet Encapsulation, PPTP or PPPoE
Encapsulation.
9.2.1 Ethernet Encapsulation
Choose the Ethernet option when the WAN port is used as a regular Ethernet. The first menu 11.1 screen
you see is for Ethernet Encapsulation shown next.