ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 106)

Prestige 324 Intelligent Broadband Sharing Gateway
Remote Node Setup 9-9
Table 9-4 Remote Node Network Layer Options Menu Fields
FIELD DESCRIPTION EXAMPLE
broadcasts.
RIP Press the [SPACE BAR] to select the RIP direction. Options are:
Both, None, In Only, Out Only or None. Please see the RIP Setup
section for more information on RIP. The default for RIP on the WAN
side is None. It is recommended that you do not change this setting. None
(default)
Version Press the [SPACE BAR] to select the RIP version. Options are RIP-
1, RIP-2B or RIP-2M.
None
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press [SPACE BAR] to enable IP Multicasting or select None to
disable it. See the previous Part for more information on this feature. IGMP-v2
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to
menu 11. Press [ENTER] at the message “Press ENTER to Confirm...” to save your configuration,
or press [ESC] at any time to cancel.
9.4 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, then press the [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by commas, e.g., 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field. For
more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP
Encapsulation, you can also specify remote node call filter sets.