ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 123)

11-8 NAT
Figure 11-4 Menu 11.3 — Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
Table 11-3 Applying NAT in Menus 4 & 11.3
FIELD OPTIONS DESCRIPTION
Full
Feature When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see section 11.3.1 for further discussion). You can
configure any of the mapping types described in Table 11-2. Choose
Full Feature if you have multiple public WAN IP addresses for your
Prestige.
None NAT is disabled when you select this option.
Network
Address
Translation
SUA Only When you select this option the SMT will use Address Mapping Set 255
(menu 15.1 - see section 11.3.1). Choose SUA Only if you have just one
public WAN IP address for your Prestige.
11.3 NAT Setup
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can
only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the SMT
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address: N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.