Toshiba PORTEGE M400 - Manual (Page 85)

2.6 2.5” HDD Troubleshooting 2 Troubleshooting
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 2-37
Procedure 3 Format Check
The computer’s 2.5” HDD is formatted using the MS-DOS FORMAT program or the physical
format program of the test program. To format the 2.5” HDD, start with Check 1 below and
perform the other steps as required.
Refer to the MS-DOS Manual for the operation of MS-DOS. For the format by the test
program, refer to the Chapter 3.
Check 1 Format the 2.5” HDD using MS-DOS FORMAT command. Type as FORMAT
C:/S/U.
If the 2.5” HDD can not be formatted, perform Check 2.
Check 2 Using the MS-DOS FDISK command, set the 2.5” HDD partition. If the partition
is not set, go to Check 3. If it is set, format the 2.5” HDD using MS-DOS
FORMAT command.
Check 3 Using the Diagnostic Disk, format the 2.5” HDD with a format option (physical
format). If the 2.5” HDD is formatted, set the 2.5” HDD partition using MS-DOS
FDISK command.
If you cannot format the 2.5” HDD using the Tests and Diagnostic program, go to
Procedure 4.