Toshiba PORTEGE M400 - Manual (Page 323)

4.31 Fluorescent lamp 4 Replacement Procedure
Removing the bezel
1. Without removing the insulation tape, turn the face of module up.
2. Release the four latches of the bezel and frame (two positions on each side). With
holding up the bezel from the lower side (FL lamp side), release the three latches on
the top to remove the bezel from the cell. (The bezel is reused.)
CAUTION: 1. Do not damage the latches and FPC.
2. When removing the bezel, be careful not to deform the bezel.
Release the three latches on the top to remove the bezel from the cell.
Figure 4-56 Replacing 12.1 Inch TMD fluorescent lamp (4)
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 4-85