Toshiba PORTEGE M400 - Manual (Page 122)

3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
3-4 [CONFIDENTIAL] PORTEGE M400 Maintenance Manual (960-541)
3.2 Executing the Diagnostic Test
To start the DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the USB floppy disk drive.
2. Turn on the computer with pressing the F12. Select the FDD in the display for
selecting booting unit. Then, press Enter and the following menu appears.
Microsoft Windows XX Startup Menu
---------------------------------------------------------
1. Repair Main (T&D)
2. Repair initial config set
3. Repair Heatrun (T&D)
Enter a choice: 1
Select the program you want to execute and press Enter. The RAID configuration check
screen will be displayed. Refer to 3.3 RAID configurations Check.
When any key is pressed, the RAID configuration check screen is completed and the
program selected is executed.
To start the Diagnostics menu (T&D), press 1 and Enter.
To start the H/W initial information setting tool, press 2 and Enter.
To start the Heatrun test, press 3 and Enter.
NOTE: After replacing the system board or CPU, it is necessary to execute the subtest
01 Initial configuration in 3.4 Setting of the hardware configuration.