Installing the mdc – Toshiba PORTEGE M400 User Manual

Page 293

4.19 MDC

4 Replacement Procedures

4. Turn up two points of insulator and disconnect the MDC cable from the connector

CN4100 on the system board.

MDC cable

CN4100

Insulator

Figure 4-36 Removing the modem cable

Installing the MDC

The following describes the procedure for installing the MDC. (See Figure 4-35 and 4-36.)

1. Connect the MDC cable to the connector CN4100 on the system board and wrap it

with insulator.

2. Connect the MDC cable to the connector on the MDC.

3. Install the MDC to the connector CN3010 on the system board and secure it with the

following screws.

• M2.0×4.0B BIND

screw

×2

PORTEGE M400 Maintenance Manual (960-541)

[CONFIDENTIAL]

4-55