Toshiba PORTEGE M400 - Manual (Page 257)

4.6 Slim select bay module 4 Replacement Procedures
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 4-19
Installing the slim select bay module
The following describes the procedure for installing the slim select bay module. (See Figure
4-8 and 4-9.)
1. Install the ODD side assembly to the optical drive assembly and secure it with the
following screws.
• M2.0×6.0S
BIND screw
×1
• M2.0×22.0S BIND
screw
×1
2. Install the connector base to the optical drive assembly and secure it with the
following screw.
• M2.0×3.0S
S-THIN HEAD screw
×1
3. Install the connector cover and connector to the optical drive assembly and secure it
with the following screws.
• M2.0×6.0S
BIND screw
×2
4. Insert the slim select bay module into the computer to connect it to the connector on
the system board. Press to ensure a firm connection.
5. Remove the following screw from the screw hole. Then secure the latch with the
removed screw. (The slim select bay is locked.)
• M2.0×4.0B BIND
screw
Ч1