Roland DR-3 - Manual (Page 87)

87
Chapter 8 Creating and Performing Songs ([SONG])
Ch
ap
ter
8
Setting a Specified Segment for Playing
Repeatedly
This sets the specified segment for playing repeatedly
(Loop Play).
1. Select the song to play, then press [EDIT].
The Edit Menu screen appears.
2. Select a , then press [ENTER].
3. Press [ ] to select a or a
, then press [ENTER].
The measure where Loop Play begins is set
with “LoopStart”; the measure where Loop
Play stops is set with the “LoopEnd” setting.
fig.08-31d
4. Turn the VALUE dial to set the starting or
ending measure for Loop Play.
5. When you press [EXIT], the setting is
changed, and you’re returned to the
previous screen.
■ Playing Multiple Songs
Continuously (Song Chain)
You can specify the song number of the song that
you want to have played right after the currently
selected song, when it is played. By setting in
each song the number of the song that is to follow
it, you can achieve continuous playback of up to
100 songs.
You can also have the performance of any
particular song(s) be repeated.
fig.08-chain
1. Select the song to play, then press [EDIT].
The Edit Menu screen appears.
2. Select a , then press [ENTER].
3. Press [ ], select a .
fig.08-35d
4. Turn the VALUE dial to select the value.
5. When you press [EXIT], the setting is
changed, and you’re returned to the
previous screen.
* Depending on its settings, there may be some delay for
the TSC (p. 51) to change, if the song is switched while
Song Chain is in progress.
Value Description
OFF
Plays back the currently selected song
one time and then stops.
REPEAT Playback of the song(s) is repeated.
S001–
S100
The selected song is played back, and
is followed by playback of the next
specified song.
Song 001
Song Chain: 002
Song 002
Song Chain: 003
Song 003
Song Chain: OFF