Clearing the song, Performing songs, Styles and songs (p. 85) – Roland DR-3 User Manual
Page 85: Ch ap ter 8
85
Chapter 8 Creating and Performing Songs ([SONG])
Ch
ap
ter
8
■ Clearing the Song
1. Press [EDIT].
The Edit Menu screen appears.
2. Select a
3. Press [
], select a
press [ENTER].
fig.08-28d
4. Turn the VALUE dial to select the number
for the song to be cleared, then press
[
].
A confirmation screen is displayed.
fig.08-29d
If you press [
], you’re taken back to the
screen you were in immediately before that.
5. Press [ENTER] to execute the clearing.
You can press [EXIT] to cancel the procedure,
and go back to the screen you were in right
before that.
*
Note that the clear process may take up to a minute or
more to complete when the data contains exclusive
patterns (p. 78).
Performing Songs
Play back the recorded song.
In addition to the normal way of performing
songs, you can also do the following.
•
Repeat playback of a specified segment
(Loop Play)
•
Switch patterns with a foot switch (Block
Loop)
•
Play multiple songs in succession (Song
Chain)
■ Performing Songs
1. With the performance stopped, press
[SONG] so the button lights up.
This puts the DR-3 in Song mode.
fig.08-30d
2. Turn the VALUE dial to select a song.
3. Press START [
] to start the
performance.
4. Press STOP [
] to stop the
performance.
*
Pressing a pattern pad in Song mode while [
] is on
and the performance is stopped starts the performance.
You cannot switch the patterns with the pattern pads.
Style No.
Measure
Loop Play Mode
Song No.
Song Name