Roland DR-3 - Manual (Page 57)

57
Chapter 5 Changing the Overall Tone of the Sound and Acoustics (TSC)
Ch
ap
ter
5
■ Naming the Settings
Select a on step 4 in p. 56, then press
[ENTER].
You can edit the name of the currently selected
Ambience setting, using up to six characters for
the name.
fig.09-27d
Press [ ] [ ] to move to the point where you
want to enter the character(s).
Each time you press [ENTER], it switches
between upper and lower case for the text being
input.
Turn the VALUE dial to select the character.
When you have finished making the setting,
press [EXIT] a number of times until you exit Edit
mode.
■ Copying the Settings
Select a on step 4 in p. 56, then press
[ENTER].
Copy the currently selected Ambience setting to
the User settings (U1–U8).
fig.09-28d
Turn the VALUE dial to select the number for the
Ambience to be copied, then press [
].
fig.09-29d
Turn the VALUE dial to select the copy-
destination Ambience number, then press [
].
fig.09-30d
Press [ENTER] to execute the copy.
If you press [ ], the copy is cancelled, and
you’re taken back to the screen you were in
immediately before that.
When you have finished making the setting,
press [EXIT] a number of times until you exit Edit
mode.
Hi Damp /
Freq 400 Hz–
16 kHz
This parameter adjusts the
standard frequency at which
the high-frequencies are
damped. The reverb sound in
the band above the standard
frequency is damped.
Low Cut /
Freq 20 Hz–
2.0 kHz
This parameter adjusts the
frequency at which the low-
frequencies are cut.
High Cut /
Freq
250 Hz–
14.0 kHz,
FLAT
This parameter adjusts the
frequency at which the low-
frequencies are cut. No effect
occurs when set to “FLAT.”
Parameter Value Description