Roland DR-3 - Manual (Page 83)

83
Chapter 8 Creating and Performing Songs ([SONG])
Ch
ap
ter
8
■ Changing the Tempo Part Way
Through a Song (TEMPO)
You can have the tempo change at a specified
measure within the song.
This changes the tempo setting in all measures
following the specified measure.
1. Press [SONG] so that the button lights
up, then press STEP REC [ ].
The Song Recording screen is displayed.
2. Press [ ] [ ] until the measure
where you want the tempo to change is
displayed.
3. Press [TEMPO (TAP)].
fig.08-21d
4. Turn the VALUE dial to select the tempo.
You can tap [TEMPO (TAP)] at least four times to
set the tempo.
5. Press [ENTER] and the tempo change will
be recorded.
If you press [EXIT], the immediately
preceding screen returns to the display.
Press [ ] and the Song display appears.
Undoing Tempo Changes
1. Press [SONG] so that the button lights
up, then press STEP REC [ ].
The Song Recording screen is displayed.
2. Press [ ] [ ] to move to the step in
which the tempo has been changed.
“Tempo” appears in the display for steps in
which the tempo has been changed.
3. Hold down STEP REC[ ] and press
[ENTER].
The tempo change is cancelled.
<5> Checking the Created
Song
Play back the recorded song to confirm the tempo
and TSC settings.
Change the settings as needed.
■ Performing the Created Song
1. Press [SONG].
2. Press START [ ] to start the
performance.
3. Press STOP [ ] to stop the
performance.
■ Editing the Settings
You can make changes to the following settings,
even after creation of the song is finalized.
•
Initial Tempo —
“Setting the Basic Tempo” (p. 75)
• TSC Settings —
“Making the TSC Settings for the Song” (p. 76)