Roland HP103e - Manual (Page 10)

HP103e/102e – Before You Start Playing
8
Before You Start Playing
Connecting the Pedal Cable
Connect the pedal cable to the Pedal jack on the
bottom panel of the instrument, at the rear.
fig.00-01
Connecting the Power Cord
1. Insert the included power cord into the AC inlet
on the bottom panel of the instrument, at the rear.
2. Plug the power cord into a power outlet.
Opening/Closing the Lid
To open the lid, use both hands to lift it lightly,
and slide it away from yourself.
To close the lid, pull it gently toward yourself, and
lower it softly after it has been fully extended.
fig.00-05
When opening and closing the lid, be careful not to let
your fingers get caught. If small children will be using the
HP103e/102e, adult supervision should be provided.
Setting up the Music Rest
Set up the music rest as shown in the figure below.
Fold the three supporting feet at the back of the rest and
check whether the stand is held in place.
Before moving the HP103e/102e, be sure to lower the
music stand as a safety precaution.
■ Using the Music Holders
You can use the holders to hold pages in place. When not
using the holders, leave them folded down.
fig.mu_stand4
Be sure to use the supplied power cord.
If you need to move the piano, make sure the lid is
closed first to prevent accidents.
NOTE
NOTE
HP103_e.book Page 8 Sunday, September 12, 2004 1:37 PM