RAD Data comm ASMI-450 User Manual
Page 86
ASMi-450 Control from the Control Port
4-28
ASMi-450 Installation and Operation Manual
•
When you see the correct and complete command in the echo line, press
command and display the appropriate response.
At the end of the command execution, the ASMi-450 displays the
current time and date, and then provides a new prompt for the next
command line.
•
If you changed your mind, and want to abort the command, press
BREAK or CTRL-C. You will again receive the prompt, so you can
enter another command.
Note
You can also use BREAK or CTRL+C to stop automatic repetition of
commands sent with the /R option.
2. If your command is not correct, the ASMi-450 will not execute it, but will
echo again the command, with a bad command message in the following
line. Type again the correct command.
3. If the terminal screen fills up during the exchange with the ASMi-450, you
will see the message:
HIT ANY KEY TO CONTINUE
After pressing any key except BREAK, the terminal scrolls to the next page.
Ending a Control
Session
1. To end the control session, type:
EXIT
2. The ASMi-450 prompt will disappear. Now you can control the ASMi-450
from its front panel.
Note
A control session may also be terminated by the ASMi-450 if the idle disconnect
time-out is enabled, or when the DTR line switches to the inactive (OFF) state.