RAD Data comm ASMI-450 - Manual (Page 83)

ASMi-450 Control from the Control Port
ASMi-450 Installation and Operation Manual 4-25
RESET -----------------------------------------------------------------------------------------
Purpose Reset the ASMi-450. This will cause the ASMi-450 to initialize, therefore the traffic
through the ASMi-450 will be disrupted until the ASMi-450 returns to normal operation.
For this function to operate the internal WD jumper (Section 2-4) must be set to ON.
Format RESET
Use 1. To reset the ASMi-450, type:
RESET
TIME --------------------------------------------------------------------------------------------
Purpose Set the time for the ASMi-450 internal real-time clock.
Format TIME
Use 1. Type
TIME
2. The ASMi-450 sends the time entry form:
HOUR = 12
MINUTE = 25
SECOND = 16
3. If necessary, change the time as follows:.
•
Bring the cursor to the beginning of the first field to be changed by pressing the
space bar.
•
To change the selected field, press F or B to scroll among the available
selections.
•
When the desired selection is displayed, press the space bar to move to the next
field.
4. Set the time about one minute beyond the current time, and then press at the
correct instant. The ASMi-450 will display the TIME and DATE fields (note that
TIME has changed), followed by the ASMi-450 prompt.