Help – RAD Data comm ASMI-450 User Manual
Page 80
ASMi-450 Control from the Control Port
4-22
ASMi-450 Installation and Operation Manual
F--------------------------------------------------------------------------------------------------
Purpose
Define the codes used to be sent to the control terminal to perform the following
terminal control functions:
•
Clear screen
•
Move cursor to screen home position.
•
Move cursor to the right by one position.
This command lets you enter manually the desired codes. However, if you are using a
terminal of the following type: VT-52, VT-100, TV-920, FREEDOM-110,
FREEDOM-220, or a terminal which is compatible with one of the terminals listed
above, you can use the DEF TERM command (see DEF TERM command) to select
automatically the corresponding control sequences.
Format
F
Use
1. To display the current codes, type:
F
2. The terminal function entry screen is displayed. The screen includes three separate
lines, displayed one after the other. A typical screen, showing all the three lines, is
shown below:
CLEAR SCREEN
=hhhhhhhh (clear screen code)
CURSOR HOME
=hhhhhhhh (cursor home code)
CURSOR RIGHT
=hhhhhhhh (cursor right code)
where h indicates hexadecimal digits.
3. To change a code, bring the cursor under the first digit of the code to be changed, by
pressing
4. Repeat the procedure until all the necessary digits are changed.
HELP -------------------------------------------------------------------------------------------
Purpose
Display an index of the control port commands and the options available for each
command.
Format
& Use
H
You will see the first HELP page. Press any key to see the next page.