RAD Data comm ASMI-450 - Manual (Page 70)

ASMi-450 Control from the Control Port
4-12 ASMi-450 Installation and Operation Manual
2. The ASMi-450 displays the node name entry form:
ENTER NODE NAME (MAX 8 CHARACTERS) =
CURRENT NODE NAME = 'name'
where 'name' is the node name the ASMi-450 is currently assigned.
3. Type the desired name, and then press . The ASMi-450 will display the TIME
and DATE fields, followed by the ASMi-450 prompt.
Note
Before entering a node name, make sure that the PSWD section of the
ASMi-450 internal switch S1 is not set to ON, because in such a case the default
name (blank) is enforced.
DEF NODE ------------------------------------------------------------------------------------
Purpose Define the node number, or address, of the ASMi-450. The allowed range is 0 to 255.
Format DEF NODE
Use 1. To define the ASMi-450 node number, type:
DEF NODE
2. The ASMi-450 displays the node entry form:
NODE (0 to 255) = 0
3. Type the desired number in the range of 0 to 255, and then press . The
ASMi-450 will display the TIME and DATE fields, followed by the ASMi-450
prompt.
Note
Before entering a node number, make sure that the PSWD section of the
ASMi-450 internal switch S1 is not set to ON, because in such a case the default
number (0) is enforced.
DEF PWD--------------------------------------------------------------------------------------
Purpose Define a new user password for the ASMi-450. The password must have 4 to 8
characters.
Format DEF PWD
Use 1. Type
DEF PWD