RAD Data comm ASMI-450 - Manual (Page 76)

ASMi-450 Control from the Control Port
4-18 ASMi-450 Installation and Operation Manual
Table 4-2. Control Terminal Alarm Messages (Cont’d)
Alarm No. Alarm Syntax Meaning State Time
16 REMOTE DB
CHECKSUM ERROR
The data base currently stored in the non-
volatile memory of the remote ASMi-450
is corrupted. Message can appear only
upon power-up
[ON] hh:mm:ss
17 REMOTE ALARM
BUFFER OVERFLOW
The alarm buffer of the remote ASMi-450
is full, and new alarms overwrite the older
alarms
[ON] [OFF] hh:mm:ss
18 REMOTE SELF TEST
ERROR
A fault has been detected in the remote
ASMi-450 during the power-up self-test
[ON] hh:mm:ss
19 REMOTE HARDWARE
FAILURE
A hardware fault has been detected in the
remote ASMi-450
[ON] hh:mm:ss
20 REMOTE PSWRD
SWITCH IS ON
Section PSWD of switch S1 of the remote
ASMi-450 is set to ON
[ON] hh:mm:ss
21 REMOTE SP-PAR
SWITCH IS ON
Section DEF SP of switch S1 of the
remote ASMi-450 is set to ON
[ON] hh:mm:ss
22 REMOTE DB-INIT
SWITCH IS ON
Section DB INIT of switch S1 of the
remote ASMi-450 is set to ON
[ON] hh:mm:ss
23 REMOTE REAL TIME
CLOCK BATTERY
FAILURE
The battery that powers the remote
ASMi-450 internal real-time clock when
ASMi-450 is not powered has failed
[ON] hh:mm:ss
24 REMOTE REVERSE
POLARITY
Reversed loop polarity has been detected
by the remote ASMi-450
[ON] hh:mm:ss
25 REMOTE SIGNAL LOSS A report of loss of HDSL input signal at
the remote ASMi-450 has been received
via the HDSL line
[ON] [OFF] hh:mm:ss
26 REMOTE SYNC LOSS A report of HDSL loss of synchronization
at the remote ASMi-450 has been received
via the HDSL line
[ON] [OFF] hh:mm:ss
27 REMOTE LOW
QUALITY ALARM
The far-end block error rate (FEBE)
reported via the HDSL line exceeds 10-7
[ON] hh:mm:ss
28 REM TRANSMIT SLIP A slip has been detected on the remote
transmit path
[ON] hh:mm:ss
29 REM RECEIVE SLIP A slip has been detected on the remote
receive path
[ON] hh:mm:ss