RAD Data comm ASMI-450 - Manual (Page 78)

ASMi-450 Control from the Control Port
4-20 ASMi-450 Installation and Operation Manual
Display
Format A typical HDSL line status display is shown below.
STATUS OF LINE
ANALOG FRONT END TYPE = 784K
LOCAL LINE ALARMS = SYNC LOSS SIGNAL LOSS
OFF OFF
The fields included in the status information display are listed below:
ANALOG FRONT END TYPE Displays the nominal data rate on the HDSL line:
784 kbps for ASMi-450/768.
LINE ALARMS Displays the state of the line alarms on the HDSL
line:
SIGNAL LOSS ON indicates loss of HDSL
input signal.
SYNC LOSS ON indicates loss of
synchronization to the HDSL
signal.
DSP ST PORT -------------------------------------------------------------------------------
Purpose Display status information on the user's port.
Format DSP ST PORT [Option]
Use 1. To display the current status information for the user's port, type:
DSP ST PORT
Display
Format A typical user's port status display is shown below.
STATUS OF PORT
INTERFACE TYPE
= 'interface'
LOCAL UNIT ACTIVATED LOOPS = LOCAL PORT REM REM PORT
NO NO
REMOTE UNIT INITIATED LOOPS = REM PORT
NO
The fields included in the ASMi-450 status information display are listed below:
TYPE Displays the type of the user's port interface
('interface' stands for the interface type: V.35,
X.21, RS-422, RS-530, or ETHERNET).
LOCAL UNIT Displays the state of each type of loopback that
can be activated ACTIVATED LOOPS by
command from the local ASMi-450 unit on either
the local, or the remote unit:
•
LOCAL PORT: local port loopback on the
local unit.
•
REM REM PORT: remote port loopback