RAD Data comm ASMI-450 - Manual (Page 69)

ASMi-450 Control from the Control Port
ASMi-450 Installation and Operation Manual 4-11
4. A typical display, as seen after all the parameters are selected, is shown below:
TELNET_APATHY_TIME 10 MIN
IP_ADDRESS XXX.XXX.XXX.XXX
READ COMMUNITY public
WRITE COMMUNITY private
TRAP COMMUNITY IS public
where X stands for the digits of the IP address.
Display
Fields The agent parameters displayed on the data form, and their range of values, are as
follows:
TELNET_APATHY_TIME Press the F or B keys to select the time, in minutes,
after which a Telnet connection will be automatically
terminated if no incoming activity is detected.
The available values are 10MIN, 15MIN, and 20MIN.
IP_ADDRESS Type in the IP address assigned to the ASMi-450
SNMP agent in the dotted-quad format (four groups of
digits in the range of 0 through 255, separated by
periods).
READ COMMUNITY Type in the name of the SNMP community that has
read-only authorization (the ASMi-450 SNMP agent
will accept only
getRequest and
getNextRequest commands from management
stations using that community). You may enter up to
32 alphanumeric characters.
WRITE COMMUNITY Type in the name of the SNMP community that has
read-write authorization (the ASMi-450 SNMP agent
will also accent
setRequest commands from
management stations using that community). You may
enter up to 32 alphanumeric characters.
TRAP COMMUNITY Type in the name of the SNMP community to which
the ASMi-450 SNMP agent will send traps. You may
enter up to 32 alphanumeric characters.
DEF NAME------------------------------------------------------------------------------------
Purpose Define the node name (up to eight alphanumeric characters).
Format DEF NAME
Use 1. To define the ASMi-450 node name, type:
DEF NAME