Renesas RJJ10J1643-0101 - Manual (Page 57)

Rev.1.01 2007.02.16
RJJ10J1643-0101 55
(Operating states set) Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The
default value is RAPI_TIMER_OFF.
(Pulse output state) Specify one from { RAPI_PULSE_ON, RAPI_PULSE_OFF }. The
default value is RAPI_PULSE_OFF.
(Gate facility) Specify one from { RAPI_GATE_L, RAPI_GATE_H }. If omitted,
“No gate facility” is set.
• Specifiable definition values when timer B is used (RAPI_TIMER_B0 to
RAPI_TIMER_B2 specified)
(Count source) Specify one from { RAPI_F1, RAPI_F2, RAPI_F8, RAPI_F32,
RAPI_FC32 }. The default value is RAPI_F2.
(Operating states set) Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The
default value is RAPI_TIMER_OFF.
(R8C)
RAPI_TIMER_X Uses timer X.
RAPI_TIMER_Y Uses timer Y.
RAPI_TIMER_Z Uses timer Z.
RAPI_TIMER_RA Uses timer RA.
RAPI_TIMER_RB Uses timer RB.
RAPI_F1 Selects f
1
for the count source.
RAPI_F2 Selects f
2
for the count source.
RAPI_F8 Selects f
8
for the count source.
RAPI_F32 Selects f
32
for the count source.
RAPI_FRING Selects f
RING
for the count source.
RAPI_FOCO Selects foco for the count source.
RAPI_FC32 Selects fC32 for the count source.
RAPI_TIMER_Y_
UNDERFLOW
Selects the underflow of timer Y for the count source.
RAPI_TIMER_RA_UN
DERFLOW
Selects the underflow of timer RA for the count source.
RAPI_TIMER_ON Sets the timer to start operating in __CreateTimer.
RAPI_TIMER_OFF Sets the timer to stop operating in __CreateTimer.
RAPI_WRITE_
RELOAD_ONLY
Selects operation mode in which writing to the primary register and
prescaler causes the set data to be written to only the reload
register.
RAPI_WRITE_
RELOAD_BOTH
Selects operation mode in which writing to the primary register and
prescaler causes the set data to be written to both the reload
register and the counter, respectively.
•
Specifiable definition values when timer X is used (RAPI_TIMER_X specified)
(Count source) Specify one from { RAPI_F1, RAPI_F2, RAPI_F8, RAPI_F32 }. The
default value is RAPI_F1.
(Operating states set) Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The
default value is RAPI_TIMER_OFF.
•
Specifiable definition values when timer Y is used (RAPI_TIMER_Y specified)