Renesas RJJ10J1643-0101 - Manual (Page 151)

Rev.1.01 2007.02.16
RJJ10J1643-0101 149
[26]: Store the value of time measurement register 3/waveform generation register 3.
[27]: Store the value of time measurement register 4/waveform generation register 4.
[28]: Store the value of time measurement register 5/waveform generation register 5.
[29]: Store the value of time measurement register 6/waveform generation register 6.
[30]: Store the value of time measurement register 7/waveform generation register 7.
[31]: Store the value of the facility select register.
[32]: Store the value of the facility enable register.
[33]: Store the value of the interrupt request register.
[34]: Store the value of interrupt enable register 0.
[35]: Store the value of interrupt enable register 1.
(R8C)
• When using timer C (RAPI_TIMER_C specified)
[0]: Store the value of the timer C register.
[1]: Store the value of the capture & compare 0 register.
[2]: Store the value of the compare 1 register.
[3]: Store the value of the timer C output control register.
[4]: Store the value of timer C control register 1.
[5]: Store the value of timer C control register 0.
• When using timer X (RAPI_TIMER_X specified)
[0]: Store the value of the timer count source setup register.
[1]: Store the value of the prescaler X register.
[2]: Store the value of the timer X register.
[3]: Store the value of the timer X mode register.
• When using timer Y (RAPI_TIMER_Y specified)
[0]: Store the value of the timer count source setup register.
[1]: Store the value of the prescaler Y register.
[2]: Store the value of the timer Y primary register.
[3]: Store the value of the timer Y secondary register.
[4]: Store the value of the timer Y & Z waveform output control register.
[5]: Store the value of the timer Y & Z output control register.
[6]: Store the value of the timer Y & Z mode register.
• When using timer Z (RAPI_TIMER_Z specified)
[0]: Store the value of the timer count source setup register.
[1]: Store the value of the prescaler Z register.
[2]: Store the value of the timer Z primary register.
[3]: Store the value of the timer Z secondary register.
[4]: Store the value of the timer Y & Z waveform output control register.
[5]: Store the value of the timer Y & Z output control register.
[6]: Store the value of the timer Y & Z mode register.
• When using timer RA (RAPI_TIMER_RA specified)
[0]: Specify the set value for the timer RA I/O control register.
[1]: Specify the set value for the timer RA prescaler register.
[2]: Specify the set value for the timer RA register.
[3]: Specify the set value for the timer RA mode register.
[4]: Specify the set value for the timer RA control register.