Renesas RJJ10J1643-0101 - Manual (Page 126)

Rev.1.01 2007.02.16
RJJ10J1643-0101 124
(TC reload) To reload TC register, specify RAPID_RELOAD. If RAPID_RELOAD is
not specified, “No reload” is set.
(CMP0 output
mode)
Specify one from { RAPI_UNCHANGE_0, RAPI_REVERSE_0,
RAPI_L_0, RAPI_H_0 }. The default value is RAPI_UNCHANGE_0.
(CMP1 output
mode)
Specify one from { RAPI_UNCHANGE_1, RAPI_REVERSE_1,
RAPI_L_1, RAPI_H_1 }. The default value is RAPI_UNCHANGE_1.
• Specifiable definition values when timer RD is used (RAPI_TIMER_RD specified)
(Count source) Specify one from [RAPI_TRD_F1, RAPI_TRD_F2, RAPI_TRD_F4,
RAPI_TRD_F8, RAPI_TRD_F32, RAPI_TRD_F40M]. The default is
RAPI_TRD_F1.
(Operating states
set)
Specify one from [RAPI_TIMER_ON, RAPI_TIMER_OFF]. The default
is RAPI_TIMER_OFF
(Interrupt) If overflow interrupt requests are enabled, specify RAPI_OVERFLOW.
If input capture A, input capture B, input capture C, or input capture D
interrupt requests are enabled, specify RAPI_INPUT_CAPURE_A,
RAPI_INPUT_CAPURE_B, RAPI_INPUT_CAPURE_C, or
RAPI_INPUT_CAPURE_D, respectively. When not specifying
interrupts, select “No interrupt requests.”
(Counter clear) To specify GRA, GRB, GRC, or GRD input capture for the cause for
which the counter is cleared, select RAPI_COUNT_CLEAR_A,
RAPI_COUNT_CLEAR_B, RAPI_COUNT_CLEAR_C, or
RAPI_COUNT_CLEAR_D, respectively. If cleared at the same time a
synchronously operating counter on another channel is cleared, select
RAPI_COUNT_CLEAR_SYNC.
(Synchronization) If timers on channels 0 and 1 are to be synchronized, select
RAPI_TIMER_SYNC. When not specifying synchronization, select
“Channels 0 and 1 operate independently.”
(count stop) Specify one from [RAPI_COMPARE_MATCH_A_STOP, RAPI_STOP].
The default is RAPI_STOP.
• Specifiable definition values when timer RE is used (RAPI_TIMER_RE specified)
(Count source) Specify one from [RAPI_TRE_F4, RAPI_TRE_F8, RAPI_TRE_F32,
RAPI_TRD_FC4]. The default is RAPI_TRD_F1.
(Operating states
set)
Specify one from [RAPI_TIMER_ON, RAPI_TIMER_OFF]. The default
is RAPI_TIMER_OFF
(Interrupt) If compare match interrupt requests are enabled, specify
RAPI_COMPARE_MATCH. When not specifying interrupts, select “No
interrupt requests.”
(Output function) Specify one from [RAPI_OUTPUT_DISABLE, RAPI_OUTPUT_F2,
RAPI_OUTPUT_F4, RAPI_OUTPUT_F8,
RAPI_OUTPUT_COMPARE]. The default is
RAPI_OUTPUT_COMPARE.
(Counter) If use 4 bit counter, spcify RAPI_4BIT_COUNTER. The default is 8 bit
counter .
(H8/300H)