Renesas RJJ10J1643-0101 - Manual (Page 128)

Rev.1.01 2007.02.16
RJJ10J1643-0101 126
RAPI_COUNT_CLEAR_S
YNC
Clear counter in sync with the synchronized other timer counter
RAPI_TIMER_SYNC Synchronizes timer on channels 0 and 1.
• Specifiable definition values when timer W is used (RAPI_TIMER_W specified)
(Count source) Specify one from { RAPI_TW_F1, RAPI_TW_F2, RAPI_TW_F4,
RAPI_TW_F8 }. The default value is RAPI_TW_F1.
(Operating
states set)
Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The default
value is RAPI_TIMER_OFF.
(Interrupt) If overflow interrupt requests are enabled, specify RAPI_OVERFLOW.
Similarly, if compare match A, compare match B, compare match C, or
compare match D interrupt requests are enabled, specify
RAPI_COMPARE_ATCH_A, RAPI_COMPARE_ATCH_B,
RAPI_COMPARE_ATCH_C, or RAPI_COMPARE_ATCH_D, respectively. If
no interrupts are specified, “No interrupt request” is set.
(Counter clear) To specify GRA compare match for the cause of counter clear, specify
RAPI_COUNT_CLEAR_A.
• Specifiable definition values when timer Z is used (RAPI_TIMER_Z0 to
RAPI_TIMER_Z1 specified)
(Count source) Specify one from { RAPI_TZ_F1, RAPI_TZ_F2, RAPI_TZ_F4,
RAPI_TZ_F8 }. The default value is RAPI_TZ_F1.
(Operating
states set)
Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The default
value is RAPI_TIMER_OFF.
(Interrupt) If overflow interrupt requests are enabled, specify RAPI_OVERFLOW.
Similarly, if compare match A, compare match B, compare match C, or
compare match D interrupt requests are enabled, specify
RAPI_COMPARE_ATCH_A, RAPI_COMPARE_ATCH_B,
RAPI_COMPARE_ATCH_C, or RAPI_COMPARE_ATCH_D,
respectively. If no interrupts are specified, “No interrupt request” is set.
(Counter clear) To specify GRA, GRB, GRC, or GRD compare match for the cause of
counter clear, specify RAPI_COUNT_CLEAR_A,
RAPI_COUNT_CLEAR_B, RAPI_COUNT_CLEAR_C, or
RAPI_COUNT_CLEAR_D, respectively.
(Synchronization) If the timer is synchronized on channels 0 and 1, specify
RAPI_TIMER_SYNC. If synchronization is not specified, “Channels 0 and
1 operate independently” is set.
• Specifiable definition values when timer RC is used (RAPI_TIMER_RC specified)
(Count source) Specify one from [RAPI_TRD_F1, RAPI_TRD_F2, RAPI_TRD_F4,
RAPI_TRD_F8, RAPI_TRD_F32, RAPI_TRD_F40M]. The default is
RAPI_TRD_F1.
(Operating
states set)
Specify one from [RAPI_TIMER_ON, RAPI_TIMER_OFF]. The default is
RAPI_TIMER_OFF.