Renesas RJJ10J1643-0101 - Manual (Page 18)

Rev.1.01 2007.02.16
RJJ10J1643-0101 16
2.7 A/D Converter Driver
The A/D converter driver sets the A/D converter, controls the A/D converter, clears
settings of the A/D converter, acquires the A/D converter value, acquires the status of the
A/D converter, and clears the status of the A/D converter.
[A/D converter driver usage example (single-shot mode)]
Here, a program example is shown for the A/D converter operating in single-shot mode
under the conditions given below.
CPU : R8C
Operating clock : fAD divided by 2
Resolution : 10 bits
Analog input pin : AN0 pin
A/D conversion start condition : Software trigger
Sample-and-hold : Enabled
A program flow and a program example are shown below.
(Program flow)
__CreateADC()
__EnableADC()
__GetADCStatus()
__GetADC()
__ClearADCStatus()
main()
Set the A/D converter in
single-shot mode
Start A/D conversion
A/D interrupt?
Clear the A/D interrupt flag
No
Yes
Read out the A/D conversion value