Renesas RJJ10J1643-0101 - Manual (Page 193)

Rev.1.01 2007.02.16
RJJ10J1643-0101 191
__EnableADC
Synopsis
Boolean __EnableADC (unsigned long data1, unsigned int data2)
data1 Setup data 1 (content differs with MCU type)
data2 Number of analog input pins used by A/D converter (differs with MCU type)
Description Controls operation of the A/D converter by starting or stopping it.
[data1]
(M16C)
RAPI_AN0 Uses AN
0
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN1 Uses AN
1
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN2 Uses AN
2
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN3 Uses AN
3
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN4 Uses AN
4
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN5 Uses AN
5
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN6 Uses AN
6
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN7 Uses AN
7
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN00 Uses AN
00
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN01 Uses AN
01
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN02 Uses AN
02
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN03 Uses AN
03
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN04 Uses AN
04
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN05 Uses AN
05
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN06 Uses AN
06
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN07 Uses AN
07
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN20 Uses AN
20
pin for the analog input pin.