Renesas RJJ10J1643-0101 - Manual (Page 189)

Rev.1.01 2007.02.16
RJJ10J1643-0101 187
RAPI_SOFTWARE_TRI
GGER
Selects software trigger.
RAPI_TIMER_RD_TRIG
GER
Selects timer RD as trigger.
• Specifiable definition values when one-shot mode is used (RAPI_ONE_SHOT specified)
(Input pin) Specify one from { RAPI_AN0, RAPI_AN1, RAPI_AN2, RAPI_AN3,
RAPI_AN4, RAPI_AN5, RAPI_AN6, RAPI_AN7, RAPI_AN8, RAPI_AN9,
RAPI_AN10, RAPI_AN11 }. Always be sure to specify an input pin.
(Operating
frequency)
Specify one from { RAPI_FAD, RAPI_FAD2, RAPI_FAD4, RAPI_FOCOF }.
The default value is RAPI_FAD4.
(Resolution) Specify one from { RAPI_10BIT, RAPI_8BIT }. The default value is
RAPI_8BIT.
(Operating
states set)
Specify one from { RAPI_AD_ON, RAPI_AD_OFF }. The default value is
RAPI_AD_OFF.
(Conversion
method)
Specify one from { RAPI_WITH_SAMPLE_HOLD,
RAPI_WITHOUT_SAMPLE_HOLD }.
The default value is RAPI_WITHOUT_SAMPLE_HOLD.
(Trigger) Specify one from { RAPI_SOFTWARE_TRIGGER,
RAPI_TIMER_RD_TRIGGER }. The default value is
RAPI_SOFTWARE_TRIGGER.
• Specifiable definition values when repeat mode is used (RAPI_REPEAT specified)
(Input pin) Specify one from { RAPI_AN0, RAPI_AN1, RAPI_AN2, RAPI_AN3,
RAPI_AN4, RAPI_AN5, RAPI_AN6, RAPI_AN7, RAPI_AN8, RAPI_AN9,
RAPI_AN10, RAPI_AN11}. Always be sure to specify an input pin.
(Operating
frequency)
Specify one from { RAPI_FAD, RAPI_FAD2, RAPI_FAD4 }. The default
value is RAPI_FAD4.
(Resolution) Specify one from { RAPI_10BIT, RAPI_8BIT }. The default value is
RAPI_8BIT.
(Operating
states set)
Specify one from { RAPI_AD_ON, RAPI_AD_OFF }. The default value is
RAPI_AD_OFF.
(Conversion
method)
Specify one from { RAPI_WITH_SAMPLE_HOLD,
RAPI_WITHOUT_SAMPLE_HOLD }.
The default value is RAPI_WITHOUT_SAMPLE_HOLD.
(Trigger) Specify one from { RAPI_SOFTWARE_TRIGGER,
RAPI_TIMER_RD_TRIGGER }. The default value is
RAPI_SOFTWARE_TRIGGER.
(H8/300H)
RAPI_ONE_SHOT Selects one-shot mode.
RAPI_REPEAT Selects repeat mode.
RAPI_SINGLE_SWEEP Selects single sweep mode.
RAPI_REPEAT_SWEEP0 Selects repeat sweep mode 0.
RAPI_AN0 Uses AN0 pin for the analog input pin.
RAPI_AN1 Uses AN1 pin for the analog input pin.
RAPI_AN2 Uses AN2 pin for the analog input pin.
RAPI_AN3 Uses AN3 pin for the analog input pin.