Printronix Network Interface Card - Manual (Page 337)

List Commands
337
is the authentication method user name.
is the authentication method password.
< power> is a percentage indicating the approximate fraction of full
power.
< option-list> is a list of options that are enabled (disabled options
are not shown).
< status> is the current access point association status
(“disassociated” or “associated with ”)
< comms-quality> indicates the strength or quality (in percent) of the
wireless signal.
NOTE: The "list stored ifc" command does not display the "Status"
or "Quality" lines.
list kerberos
For Wireless NIC with Symbol RF cards only.
list key
List the license details and license key number.
list logins
List any active user logins on the NIC.
list logpath [logpath]
List the current logpath settings (e.g., names and mapped
destinations).
list model [model]
List the current model settings (e.g., names and mapped
destinations). With no
model parameter, a table of values for
name, type, banner, config and the size in bytes of header and
trailer are shown for all models m1 through m8. When the
model parameter is supplied, the specific bytes used in the
header and trailer are shown, along with the banner type, data
type and configuration number for that specific model.