Printronix Network Interface Card - Manual (Page 135)

Manual System V Host Setup
135
Solaris 2.6 – 7 NIC Setup
NOTE: Requires Superuser privilege in the borne shell. Assume
that you can ping and Telnet to the adapter.
The IP address of the NIC adapter must be placed in the /etc/hosts
file.
Syntax:
lpadmin -p [queue_name] -v /dev/null
lpadmin -p [queue_name] -i /usr/lib/lp/model/
netstandard
lpadmin -p [queue_name] -o dest=[host_name] -o
protocol=bsd -o timeout=60
lpadmin -p [queue_name] -s [host_name]!d1prn -I any
enable {queue_name]
accept [queue_name]
where
[queue _name] = any name, but not the name in the etc/hosts file or
d1prn
[host_name] = name in etc/hosts file
Troubleshooting
This installation procedure assumes that the NIC adapter is
configured with the correct IP address, subnet mask, and gateway
(if required). You can also ping and telnet to the NIC adapter.
Print an E-Net Test Page to verify the Ethernet settings.
(P5000, T5000e/SL5000e, T4000) DIAGNOSTICS Printer
Tests E-Net Test Page Enter.
(P7000, T5000r/SL5000r) DIAGNOSTICS Printer Tests
Ethernet Test Enter.
(L55xx, L1524) DIAGNOSTICS Test Pattern E-Net Test
Page Enter.
Solaris 2.6 – 7 NIC Setup