Printronix Network Interface Card - Manual (Page 316)

Chapter 15 Complete Command List
316
store pserver smb workgrp
Example: store pserver smb workgrp eng
Define a different Windows workgroup as defined by
for the NIC to be visible within (should be 14
characters or less). By default, the print server only comes up
within the group called “WORKGROUP.”
store pserver lpd [-]dest1default
Example: store pserver lpd dest1default
If dest1default is disabled and upon verification, the printer
name supplied by the LPR protocol and the destination name
do not match, then an error message is returned and the
service is refused. If dest1default is enabled and upon
verification, the printer name supplied by the LPR protocol and
the destination name do not match, then the job is
automatically routed to the first destination and the service is
accepted.
Default: enabled
store pserver from default
Set all general print server settings back to factory defaults.
store pserver from current
Store all current general print server settings to flash memory
so they are retained after a power cycle. This ensures all
current settings match what is stored in flash memory.
ADAPTER,
WLAN
ADAPTER
store rprinter add
Example: store rprinter add pserver1 0 d1prn
Add the RPRINTER settings on the NIC for a Novell
environment. must be the name of an existing
PSERVER.NLM on your Novell file server. is
the printer number within this PSERVER.NLM. is the
queue on the NIC where the print jobs will be sent to.