Printronix Network Interface Card - Manual (Page 334)

Chapter 15 Complete Command List
334
set user passwd []
Example: set user passwd eng mplex1
Assign a password to a defined user on the NIC.
set user type root|guest
Example: set user type eng root
Assign root or guest privileges to a particular user defined by
username . Guest permissions allow viewing of settings only.
Root permissions allow complete control of the NIC.
set user from default
Set all user settings back to factory defaults.
set user from stored
Set all current user settings to the values stored in flash
memory.
set user passwd snmp
Set the new SNMP R/W community name as the
value.
set var []
Example: set var LANDSCAPE 0x1b 0x26 0x6c 0x31 0x4f
Define a new variable to be used in header, trailer, or switch
strings on the NIC and call it
.
can be a space-separated list of words,
hexadecimal numbers (e.g., 0x04), or references to other
pre-defined variables. It is easiest to make up the
with hexadecimal values, as shown in
the example.
NOTE: One variable counts as one element within header and
trailer strings.
Defined variables are referenced in strings by placing a “$”
before the variable name (e.g., set model m1 trailer
$FF ).
set var from default
Set all variable settings back to factory defaults.
set var from stored
Set all current variable settings to the values stored in flash
memory.