Printronix Network Interface Card - Manual (Page 184)

Chapter 7 Novell Host Configuration (10/100Base-T)
184
Manual (Telnet) Method
1. Telnet to the print server:
telnet ipaddress
NOTE: If prompted for a User ID and password, type in root for
the ID and press ENTER at the password prompt (since
there is no password by default).
2. You should see a prompt with the NIC IP address:
ipaddress:root>
3. At the prompt, enter:
store pserver novell tree tree
4. Reset the unit to make the changes take effect.
reset
Novell Host Configuration (10/100Base-T)
ADAPTER,
WLAN
ADAPTER
This section covers PSERVER and RPRINTER/NPRINTER setups
on the NIC. The NIC can handle up to eight RPRINTER/
NPPRINTER setups.
Although the entire print setup is done through Netware
Administrator or PCONSOLE, you may need to communicate
directly with the print server in order to modify settings, monitor the
unit, etc.
For Netware 4. x and Netware 5.x environments, you can obtain a
NWAdmn3 x snap-in program called MPAdmin. This snap-in can be
used to configure PSERVER setups as well as additional settings
on the NIC.
NOTE: NWAdmn3 x is only included with Netware 4.11 and higher
releases. If you are using Netware 4.10, you can either
upgrade to Netware 4.11 or go to Novell’s Web site and get
the patches to upgrade the Nwadmin program for Netware
4.10 to Nwadmn3
x for Netware 4.11. Alternatively, you can
perform the setup without using MPAdmin.