Printronix Network Interface Card - Manual (Page 164)

Chapter 6 Novell Host Configuration
164
14. Type in the name of one of the default destinations on the unit
for the Name field, and go to the Type field.
15. Press ENTER at this field and select Defined Elsewhere. If
Defined Elsewhere is not available, choose Parallel.
16. Press ENTER on the Print Queues Assigned field.
17. Click Insert to display all queues; select the one you defined in
step 5 and press ENTER.
18. Select a priority and press ENTER. Priority 1 should be
sufficient.
19. Press Escape until you are back to Main Menu.
20. Reboot the Print Server by repowering the printer.
21. Check the Currently Attached Servers and verify the print
server is active.
22. Press Escape until you are out of the PCONSOLE.
Even though the entire print set up is done through PCONSOLE,
you may want to communicate directly with the print server in order
to modify settings, monitor the unit, etc. To communicate with the
print server, the optional host software, npsh.exe, is included.
npsh.exe is a DOS executable program that can be run from a
DOS prompt on a NetWare workstation.
npsh.exe performs the following:
• npsh nvplist
Lists all of the NIC devices on the network; each name is in the
default format. For the integrated NIC, the default is P_xxxxxx,
For the external (E-Net) Adapter, the default is M_xxxxxx,
where xxxxxx represents the last six digits of the NIC address
found on the configuration printout or control panel settings
under Ethernet Parameters, MAC address.This is regardless of
whether it is configured as a PSERVER or as an RPRINTER.